| 1. | Poor viscosity of melting materials
2熔融材料流动性不良。 |
| 2. | Simple process procedure , easy solidified from melt material
简化工艺流程，物料由熔融状态到最终固化，一步完成。 |
| 3. | Thermo - melt material
热溶材料 |
| 4. | Low temperature of the convergence point of the melting materials , making the incomplete melting during the process
4熔融材料合流部分温度太低，使合流时未能充分熔合。 |
| 5. | The lines are the small lines resulted from the convergence of melting materials of two kinds or more . the causes are
结合线是二道或二道以上熔融材料合流所形成之细线，发生之原因如下： |
| 6. | The buddha of molten material of the buddha statue , 48 - meter - high , weighing 660 tons , and 10 from the pedestal as the pu composition
金佛系铜铸镏金工艺佛像造像，通高48米，总重量达660吨，由台座和十方普贤像组成。 |
| 7. | Materials are fused together using ultrasonic energy which generates vibrations that melt materials seamlessly together at temperatures above 250 celsius
通过利用可以产生震动的超声波能量将材料溶和在一起，这种震动在高于250慑适度的温度下将材料无缝熔化。 |
| 8. | It is found that the effects of the latent heat are not negligible in the laser cladding process and their errors depend on the temperature range during phase transformations and the size of melted material region
计算结果表明，在激光涂敷过程的温度场分析中，潜热的影响不是总可以忽略的，其误差取决于材料在物相转变时交界面温差的?围及材料熔解体积的大小。 |
| 9. | Flow mark is the imprint of the movement of melting materials and is in linear pattern to surround runners . the flow mark is resulted from fast condensation of materials inside the mold cavity and is the lines caused when the materials run in
流纹flow mark是熔融材料流动的痕迹，以浇口为中心而呈现条纹形状，流纹是先注入模腔内之材料冷却过快，而与其后流入之材料间形成界线所致。 |
